MUHAMMAD FATIH AL-AZHAR™
Gender : 
Birthday : 1980-01-11
Lokasi : BANGKINANG
Job/hobbies : Leader and Web Master
 |  Subject: Samsung S3650 Genio disassembly  14th May 2012, 10:52 | |
|
- Remove your back cover, battery, sim and memory card. Six screws
need to be removed, circled in red. Once you have removed the screws you
can remove the battery compartment. To do so, pry open the clips,
circled in white, then pry the battery compartment away from the rest of
the phone.
- Below you can see the battery compartment coming away from the rest
of the phone.
- With the battery compartment removed your phone should look like
below. A ribbon connector (circled in blue)
needs to be disconnected. It attaches like a plug and socket. Just lever
this up to unplug. A second ribbon connector, circled in white, needs to
be disconnected. To do so, lift the black part, which is on a hinge, up
towards the ribbon. Then pull the ribbon out of the socket. The switches
for the camera and volume buttons, indicated by the arrows, are stuck to
the side of the phone with double sided tape. Peel each switch away from
the side of the phone being careful not to damage the wire which
connects each switch to the circuit board. Now remove the four screws
you can see. The two at the bottom of the phone are longer than the two
at the top. Remember this when you put the phone back together.
- You can now simply lift the circuit board away from the rest of the
phone, as shown below. Now pull the front cover in the direction of the
arrows. This will release the grey plate which covers the back of the
LCD screen.
- With the grey plate removed your phone will look like below.
- Now carefully slide something thin a flat, like a credit card or
guitar plectrum, under the outer edge of the LCD screen. This will
release the double sided tape holding it in place.
- You should now have the LCD screen removed. Reverse the whole
procedure for reassembly.
|
|
Register 
Log in 
